• Working mode
    This drill is designed for carrying out complex drilling operations. The high torque is achieved due to the installed reduction gear. In this case, the dimensions are kept compact and it is possible to carry out work with one hand. The drill performs complex work with drill bits up to 25 mm in diameter, and is also capable of performing a number of other works.
  • Control system
    For a comfortable and long-lasting operation, the drill is equipped with a button with a speed control function, allowing you to perform work requiring the least number of rotations. The reverse arrangement is designed for maximum comfort to the operator, with a change of rotation, without interrupting the drilling process. The locking button located on the handle ensures continuous operation of the tool when it is switched on. The main direction of this function is to facilitate the drilling process for a long time as much as possible.
  • Metallic gearbox case
    Metal gear housing is installed in the drill to maintain the integrity and operating state of the gear unit. The metal housing provides reliable fixation of internal components, increasing the tool life. In addition to indicators, such as strength, the metal gearbox better dissipates heat, reducing the likely excess of operating temperature during prolonged work with the tool.
  • Drill chuck
    The drill is equipped with a quick-action chuck for comfortable work. The purpose of this chuck is to minimize the time to replace the rig, when performing work requiring frequent replacement of used accessories. Unlike the key chuck, the quick-action chuck does not require a special clamping wrench.
  • Engine

    Preservation of small dimensions of the electric motor is achieved by using a copper winding. Using a copper winding not only affects the dimensions of the motor, but also the power. Impregnation with varnish insulation of windings increases the electrical and mechanical quality of insulation, increases resistance to heat, moisture resistance and improves its thermal conductivity. The main purpose of the varnish coating is to remove moisture from the pores of the insulating materials, fill these pores with liquid lacquer and dry the lacquer to make it solid. For mechanical protection of insulation after final impregnation with varnish and drying of the windings, they are covered with an additional layer of varnish.

  • Gearbox
    The components of the reduction gearbox are made of high-quality metal alloys designed to withstand long and heavy loads. To increase such indicators as wear resistance and reduce friction, special lubricants are used to ensure a long tool service. The bearings of closed type are placed on the shaft for accurate transmission and reduction of resistance.
id: 00037
Tex.AC TA-01-205 electric drill with a reducing gear in a metal case and an electric battery with the power of 700 W provides high rotation torque. The speed of rotation of the cartridge to 1150 rpm, allows you to perform complex drilling operations with large diameter drills. The power button with increased life is installed on the tool and designed for continued operation.

Characteristics
Мodel ТА-01-205
System nominal voltage (W) 220
Network rated frequency (Hz) 50
Power rating (W) 700
Amount of free movement rotations (rpm) 0-1150
Number of stokes (min) no
Diameter of steel drilling (mm) 13
Diameter of concrete drilling (mm) 16
Diameter of wood drilling (mm) 24
Cartrige diameter (mm) 1,0-10
Infinitely variable speed control yes
Power cable length (cm) 200
Weight (kg) 1,4
Warranty (mon) 24