• Working mode
    The heat gun works in three modes. The first mode is responsible for blowing, drying the surface. Switching to the second or third mode, the work related to heat treatment is performed, heating the air flow to 650 degrees. At maximum temperature, the heat gun copes with the soldering of various polymer and shrink materials. Heat gun is also designed for work on the removal of old paintwork materials from various surfaces.
  • Nozzle
    Regular air heating provides a placed spiral inside the nozzle. Passing through spiral heating coils, the air warms up to the required temperature. Ceramic inserts are used to hold the heating element. At the output we get the air flow heated to the required temperature, allowing conducting various types of work where heat treatment is required.
id: 00063
Tex.AC TA-01-053 heat gun is a universal tool designed for performing thermal works. The three-position temperature switch ensures optimal performance of the removal of various coatings from the surface. An additional temperature regulator located on the body of is designed to smoothly adjust the temperature of the air flow.

Мodel ТА-01-053
System nominal voltage (W) 220
Network rated frequency (Hz) 50
Power rating (W) 300/2200
Air temperature 1 mode (°) 60
Air temperature 2 mode (°) 90-400
Air temperature 3 mode (°) 90-650
Air volume 1 mode (l/min) 600
Air volume 2 mode (l/min) 400
Air volume 3 mode (l/min) 600
Power cable length (cm) 170
Weight (kg) 0,7
Warranty (mon) 24